How to wash Cloudiness on Lacquer Furniture
The cloudiness that develops in a lacquer finish is due to moisture in the atmosphere, and also to restore the clarity of this end, you need to find a way to remove that moisture. The problem might appear intractable when moisture is trapped under a finish that’s previously hardened, but resolving it is not that difficult. Reducing room humidity is a good way to get started. Follow up by softening the end or coaxing out the humidity.
Lacquer Blushing
Among the problems which finishing professionals experience when spraying lacquer is blushing, a condition whereby the end turns milky white as it dries. This is caused by moisture from the atmosphere — it has trapped under the surface, and the microscopic water particles diffuse light which strikes the surface. Usually, the answer is to decrease humidity in the atmosphere and spray again. When the brand new lacquer softens the present finish, the water can disappear, and the blushing disappears. Sometimes the situation calls for the addition of a retarder to the lacquer to slow the drying and provide the moisture more time to escape.
Handling Blushing at Home
The clouding of your lacquered furniture is the same phenomenon encountered by finishing professionals, and it’s possible to handle it in precisely the same way. The most important step in the procedure is to decrease the humidity inside the room. That could be sufficient to remove the cloudiness from the end, because the humidity, that has seeped into microscopic cracks, can disappear through those cracks if the humidity is low enough. If the cloudiness persists, clean any wax or polish with soap and water, then spray on a light coat of lacquer or lacquer thinner when dry. It must soften the end enough for your trapped moisture to escape, and the end will harden again in under one hour. Ventilate the room adequately when inserting the newest lacquer finish.
Water Spots and Rings
White patches and rings on a lacquered tabletop are also caused by moisture — generally condensation produced at the base of a hot dink container. A simple way to eliminate these spots is to cover them with mayonnaise. The oil from the mayonnaise — generally olive or safflower oil — seeps to the exact microscopic cracks through which the humidity entered and displaces the water. It may take several hours for this to workwith. Prevent your dog or cat from thinking you left them a treat by covering the mayonnaise with a rag while it’s functioning.
Furniture Care and Factors
Lacquer provides a durable finish, but it gets brittle and cracks over time, and though the cracks are not large enough to see, water can seep through them. Prevent premature splitting by maintaining you furniture out of direct sunlight and giving it an occasional treatment with furniture polish or lemon oil. If you notice clouding, it’s likely because the humidity in the room in too high, and should youn’t do something about that, other difficulties may develop, such as warping or veneer lifting. If you can’t reduce humidity by turning up the heat, it might be a good idea to run a dehumidifier in the room occasionally.