Category: Kitchen Cabinets

How to Retrofit a Corner Cabinet Carousel in a Kitchen

How to Retrofit a Corner Cabinet Carousel in a Kitchen

Corner cabinets in a kitchen frequently result in useless space since the items stored there are difficult to see, much less reach, when they’re wanted. Retrofitting a corner cabinet with a carousel allows for simpler access and provides more usable storage space. There are two choices for retrofitting the corner cabinet to incorporate a new carousel. Select the option that fits your budget and your ability to use power tools and crawl into a little space.

Retrofit With Current Shelves

Assess the width of the corner cabinet across the wall to the interior. This measurement will help determine how large of a carousel it is possible to install.

Assess the opening of the cabinet. You will need the width and length. This measurement is the second deciding factor in the magnitude of the carousel.

Select a carousel that will fit through the opening of the cabinet. Make sure the carousel is approximately 5 inches smaller than the interior of the cabinet so you can lay it flat after it is inside.

Remove any adjustable shelves. Set them apart; you’re going to reinstall them after your carousel is set up.

Place a carousel on the bottom of your cabinet. Turn the carousel to make certain that it doesn’t rub against the sides of the cabinet. Make sure the cabinet door may shut all of the way.

Put the first shelf in addition to the underside carousel. Do not install the shelf.

Place the next carousel in addition to the shelf. Continue this process for the remaining shelves or until you’ve got the desired variety of carousel units in the cabinet.

Raise the initial shelf into place and replace the hardware that holds it. You will lose a small quantity of vertical space, which means you might need to correct the original positioning of the shelf.

Continue to lift and replace hardware to get the remaining shelves.

Retrofit Without Using Existing Shelves

Eliminate the closet door with a drill or screwdriver. Put the hardware and cabinet door aside.

Remove any present shelves with a hammer or crowbar. Be careful to not damage the structure of the cabinet.

Clean any debris from the cabinet. Check that there are no exposed nails or screws that may damage your carousel.

Assess the width of the cabinet along the wall within the cabinet. Assess the length and width of the cabinet opening. Use these measurements to choose a carousel that will fit through the opening and lay flat once within the cabinet.

Assemble the carousel after the manufacturer’s directions. You will likely need to assemble the carousel within the cabinet.

Place the assembled carousel in order that it may rotate freely and enable the door to shut.

Mark the screw holes for the top of the carousel with a permanent mark.

Move the unit apart and drill one pilot hole. Place the unit back in place.

Secure the unit by screwing one screw through the pilot hole previously drilled. The screw only has to be finger tight.

Verify the unit is flat by putting a flat together with the stick of the unit and adjust it as needed. If the unit isn’t level the carousel will not rotate properly.

Mark the screw holes for the bottom of the unit. Unscrew the single screw and move the whole unit aside.

Drill pilot holes for the remaining screws. Wash any sawdust in the bottom of the cabinet.

Put the unit in place and drill the screws into place.

Replace the cabinet door.

See related