The best way to Attach Dry Wall to Plaster Walls
In the event the plaster walls in your house are very costly expensive to fix or un-attractive, it is possible to cover them with dry wall and begin clean. Drywall wants a substrate that is strong, therefore fasten free plaster again to the wood lath strips with plaster screws behind it. Plaster screws have a washer-type fitting that AIDS in preventing the plaster. Scrape any plaster and fill the hollow that is ensuing having a patch of dry wall. The partitions are generally sound enough for dry wall once aged plaster is stabilized.
Pry off the window, baseboards and door trim and crown molding in the area together with the end of a prybar. Number the back of every bit of trim to assist you re install the parts properly.
Remove faceplates covering light switches and retailers using a flathead screw-driver.
Locate the wall studs on the other side of the plaster using a studfinder. The majority are are battery-powered, although finder procedure is different somewhat by producer. As a studfinder is handed across a wall, lights or sounds signal the elevated wall density that signifies a stud in the finder. Following the manufacturerâs working directions, locate the studs through the room and mark the areas in the bottom edge of the wall as near the ground as possible. If eliminating the baseboards uncovered portion of the wall studs in the floor-level, you donât require to mark the studs on the wall.
Place a row of 1 inch- boards on the ground across the bottom of one wall. Transfer the places in the wall along to the boards on the ground, marking the tops of the boards using a pencil. These boards are spacers that that creates an expansion gap between the edge of the floor as well as the dry wall.
Set the sheet of dry wall from the wall and rest the edge together with the row of spacer boards.
Insert 2inch drywall screws throughout the drywall and to the wall studs on the other side of the plaster using a power drill along with a Phillip’s-head screwdriver bit. Use the marks on the spacer boards as an area guide that is stud. Space screws roughly 6″ aside along every stud, but donât insert screws closer than 3/4 inch from the edges of the dry wall.
Hang the the remaining of the dry wall on the wall, leaving a 1/8 inch space between sheets, before you reach the conclusion of the wall. Measure and mark the place of the obstacle as you approach an obstacle for example an outlet or mild change and minimize out the opening having a utility knife.
Subsequent to the wall is full pull out the spacer boards, and shift the boards to the following wall.
Scratch the aged stud place marks on the boards out, make new marks that are stud as required continue hanging drywall across the space in much the same.